Graphic Editor Guide

• Graphic Editor Interface
  • Interface Introduction
    • Minimap
    • Coordinate
    • Enter Coordinate
    • Feature Information Display
    • Selected Feature Count
    • Layer List
    • Unit Options

Graphic Editor Interface

Interface Introduction

• ：ezCAM verison and user information

• ：Dropdown Menu

• ：Current Job

• ：Current Step

• ：Open Matrix Viewer

• ：Layer Filter

• ：Layer List

• ：Current number of selected feature

• ：Enter coordinate

• ：Current coordinate

• ：Minimap

• ：Graphic Editing Screen

• 

​

Minimap

• Shows the displayed screen area in the whole layout

Coordinats

• Shows the current coordinate of the mouse cursor location

Enter Coordinate

• Coordinates can be entered here for functions

：

• Absolute Coordinates Mode
  • Origin coordinate location is (0.0)
  • X and Y axis is used to show coordinate location in reference to origin coordinate

：

• Relative Coordinates Mode
  • Coordinate value changed to Angle(A) and Length(L)
  • Relative coordinate is calculated based on the relative location of specified coordinate location

• Coordinate Dropdown Menu:

• Profile center： Input coordinate for Step Profile Center
• Profile lower left： Input coordinate for Step Profile lower left corner
• Profile upper left： Input coordinate for Step Profile upper left corner
• Profile upper right： Input coordinate for Step Profile upper right corner
• Profile lower right： Input coordinate for Step Profile lower right corner
• Work layer center：Input coordinate for center of the current work layer
• Step Datum：Input coordinate for Step Datum
• Selected features center： Input coordinate for selected feature center

Feature Information Display

• Selected feature information will be displayed on the buttom of the graphic editor interface

Example

• l3p：Name of the layer
• #4：Feature serial number
• Surface：Feature Type
• XC，YC：Feature location
• DX，DY：Feature size
• Island：Number of islands
• Hole：Number of holes
• POS：Feature polarity

• To open feature information log, click on the feature information display message, log is shown in chronological order

• Shift + click on feature information display message : Open feature information table for the selected feature

Selected Feature Count

• Shows the total number of selected features

Layer List

• Shows all layers in the current job

Layer Status Display

Command：work_layer

：Blue hollow square on the left shows it's the current work layer

：Red square on the left shows it's affected layer

：Arrow sign shows the layer with current selected feature

： sign shows this is the snap layer, it is used to specify the reference layer when aligning two layers

Layer Filter

• Right Click on the to open layer filter

  • Active Layer: set the layer as ac work layer ( Command：affected_layer )
  • Snap Layer： set the layer as reference layer ( Command：snap_layer )
  • Affect None: clear all affect layers ( Command：affected_layer )
  • Affect All：set all layers as affected layer ( Command：affected_layer )
  • Affect Board: set all board layer as affected layer ( Command：affected_layer )
  • Affect Filter：Open Layer Filter Popup, filter to set affected layers ( Command：affected_filter )

Unit Options

Command：units