Profile Checks

• Profile Checks
  • Open Profile Checks
  • Parameters
    • Layer
    • Feature to Profile
    • Test List
  • Set Range
    • Feature to Profile
    • Feature to Step & Repeat
    • Feature Overlap Step & Repeat
    • Board length
    • Board width
    • Conveyed Edge Gaps
  • Run Profile Checks
  • View Analysis Report
  • Result Viewer Form
    • View Analysis Report
    • Result Viewer Form

Profile Checks

• Profile Checks analyzes Profile for design errors and creates a report to list all the findings
• Profile Checks only provide analysis check, does not change layout content
• Step Profile must be defined first

Open Profile Checks

• In Graphic Editor screen, select "Analysis" ，then select " Profile Checks" 。( Command：chklist_single )

Parameters

• Parameters values can be changed in the respective fields and saved in ERF
• All values and settings shown in this guide is by default
• Parameters interface are shown below ：

Parameters

Layer

• Select layer to run analysis

Feature to Profile

• Set analysis range distance for feature to profile frame

Test List

• Availalbe items：
  • Size ：Analyze Profile size
  • Spacing ：Analyze spacing between feature and profile
  • Gaps ：Detect gaps in profile frame

Set Range

Command：chklist erf range

• Set range value for each analysis check items
• There are three types of analysis result: Critical, Warning or Safe
• Default setting is avaialble for all parameters
• Value can be changed in respective fields, and saved in ERF
• See below picture for the Range interface：

Range

Feature to Profile

• Set analysis result range for spacing between feature and profile frame

Feature to Step & Repeat

• Set analysis result range for spacing between feature to Step & Repeat

Feature Overlap Step & Repeat

• Set analysis result range for feature overlap with Step & Repeat

Board length

• Set analysis result range for Profile Board length

Board width

• Set analysis result range for board width

Conveyed Edge Gaps

• Set analysis result range for conveyed edge gaps

Run Profile Checks

• Run Profile Analysis Command：chklist_run
• Three buttons in the lower interface, each button runs the module at different area range
  • Global ：Analyze all features in the layer ( Command：chklist_cupd )
  • Screen ：Analyze all features in the screen display area( Command：chklist_cupd )
  • Profile ：Analyze all features in profile frame( Command：chklist_cupd )

View Analysis Report

• Click the " ＋ " button on the lower right to view analysis report ( Command：chklist_ res_show )

• Result Viewer Form will be opened after click on the " ＋ " button

Result Viewer Form

• In Result Viewer Form, Severity report will be displayed based on selected layers

View Detected Error in the Layout

• In Result Viewer Form, click " <-- " or " --> " to view each error entry in the layout (See example below)

• Click "Show All" will highlight all the error spots in the layout(See example below)

View Result Histogram for Analysis

• Select an error entry, click the bar icon on lower right to open Result Histogram

Command：chklist hist close

Command：chklist hist show

• Example of Result Histogram ：